For application on aboveground and belowground metal surfaces, pipe or fittings to prevent corrosion. Excellent for use when abrasive blasting or painting is impractical. Resists weathering and UV without the need for an additional outercoat or outerwrap.
Wire brush and scrape the surface clean of loose mill scale, rust, paint and other foreign matter. Apply a thin film of Wax-Tape Primer. If the surface is wet, cold or rusty, then rub and press on primer firmly to displace the moisture and ensure adhesion. Then wrap #2 Wax-Tape using a 1” overlap. While wrapping, press and mold the tape into conformity, ensuring that there are no air pockets or voids, so that the tape is in intimate contact with the surface. Also, press and smooth out lap seams to ensure that they are sealed. If the tape is going to be painted, allow a few days for it to firm up.
- 4" x 9' rolls (24 rolls/case) 35 lbs/case
- 6” x 9’ rolls (16 rolls/case) 35 lbs/case
- Special widths and lengths available
- Minimal surface preparation
- Readily conforms to irregular shapes
- Nontoxic, non-carcinogenic, contains low VOCs
- Resistant to corrosive industrial atmospheres
- Can be applied over wet surfaces
- Compatible with other coatings
- Tape firms up and does not require additional outercoat or outerwrap
- Excellent resistance to “weathering” and UV
- Can be painted after firming up